Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
ethernet cfm enable
116
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
ethernet cfm enable
To enable connectivity fault management (CFM) processing globally on a device, use the ethernet cfm
enable command in global configuration mode. To disable CFM processing globally on a device, use
the no form of this command.
Note This command was replaced by the ethernet cfm global command in Release 15.0(1)MR.
ethernet cfm enable
no ethernet cfm enable
Syntax Description This command has no arguments or keywords.
Command Default Ethernet CFM is disabled.
Command Modes Global configuration (config)
Command History
Usage Guidelines Ethernet CFM is disabled by default and must be enabled explicitly. When CFM is configured, hardware
resources (for example, port-ASIC match-registers) are allocated for CFM.
Examples The following example shows how to enable CFM processing globally on a device:
Router(config)# ethernet cfm enable
Related Commands
Release Modification
12.2(33)SRA This command was introduced.
12.4(11)T This command was integrated into Cisco IOS Release 12.4(11)T.
12.2(33)SXH This command was integrated into Cisco IOS Release 12.2(33)SXH.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
15.0(1)MR This command was replaced by the ethernet cfm global command in Cisco
IOS Release 15.0(1)MR.
Command Description
ethernet cfm enable
(interface)
Enables connectivity fault management (CFM) processing on an
interface.
To Next Page
Loading...
