Cisco MWR 2941 - Link-Protection Management Vlan

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
link-protection management vlan
211
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
link-protection management vlan
To specify the management VLAN used for all configured link protection groups for Microwave 1+1
Hot Standby Protocol (HSBY), use the link-protection management vlan command in global
configuration mode. To remove a management VLAN configuration, use the no form of this command.
link-protection management vlan vlan-id
no link-protection management vlan vlan-id
Syntax Description
Command Default The default management VLAN is 51.
Command Modes Global configuration
Command History
Usage Guidelines Use this command to specify the management VLAN for a link protection group, also referred to as a
link protection pair.
VLANs 1-50 are reserved for IDU-to-ODU Continuity Check Message (E-CCM) and ODU-to-ODU
Continuity Check Message (P-CCM) VLANs and are not for use as the management VLAN.
Use this command to configure Microwave 1+1 Hot Standby Protocol (HSBY). For more information
about HSBY, see the Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide,
Release 15.0(1)MR.
Examples The following example show how to configure a link-protection management VLAN.
Router# configure terminal
Router(config)# link-protection management vlan 60
Router(config)# exit
Router#
Related Commands
vlan-id Specifies the management VLAN number. Valid values are 51–4094.
Release Modification
15.0(1)MR This command was introduced.
Command Description
link protection group Specifies the link-protection group of which the MEP interface is a
member.