EasyManua.ls Logo

Cisco MWR 2941 - Network-Clock Clear Wait-To-Restore

Cisco MWR 2941
708 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
network-clock clear wait-to-restore
260
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
network-clock clear wait-to-restore
To stop the wait-to-restore timer for a clock source, use the network-clock clear wait-to-restore
command in privileged EXEC mode.
network-clock clear wait-to-restore {interface interface-name slot/card/port | controller {e1 |
BITS} slot/port}
Syntax Description
Command Modes Privileged EXEC (#)
Command History
Usage Guidelines This command can cause the router to switch clock sources by restoring a previous clock source.
Examples This example shows how to use the network-clock clear wait-to-restore command:
Router# network-clock clear wait-to-restore controller e1 0/0
Related Commands
interface Specifies the interface connected to the clock input.
interface-name The name of the interface connected to the clock input.
slot The slot of Router/Switch where the clock source is present.
card The bay in which card is inserted.
port The port of the card.
controller Specifies the controller connected to the clock source.
e1 Specifies the E1 controller.
BITS Specifies the BITS controller.
slot The slot of Router/Switch where card is present.
port The port in the card.
Release Modification
15.0(1)MR This command was introduced.
Command Description
network-clock clear
lockout
Clears a lockout condition and makes a network clock input available for
clock selection.
network-clock clear
switch
Clears a forced switch or manual switch state from a synchronous
Ethernet interface.

Table of Contents

Related product manuals