Cisco MWR 2941 - Network-Clock Synchronization Participate

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
network-clock synchronization participate
277
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
network-clock synchronization participate
To configure the router to exchange timing messages using the G.781 synchronization option 1 or 2, use
the network-clock synchronization participate command in global configuration mode. To disable a
G.781 synchronization option, use the no form of this command.
network-clock synchronization ssm option {1| 2 {GEN1 | GEN2}}
no network-clock synchronization ssm option {1| 2 {GEN1 | GEN2}}
Syntax Description
Command Default 1
Command Modes Global configuration (config)
Command History
Usage Guidelines This option is only available if supported by the router.
Examples This example shows how to name a region:
Router(config)# network-clock synchronization ssm option 2 GEN1
Router(config)#
Related Commands
1 Configures G.781 synchronization option 1; this option is for use with European
synchronization networks.
2 Configures G.781 synchronization option 2; this option is for use with North
American synchronization networks.
GEN1 Specifies option 2 Generation 1 synchronization.
GEN2 Specifies option 2 Generation 2 synchronization.
Release Modification
15.0(1)MR This command was introduced.
Command Description
network-clock
input-source
Selects an interface or external timing input as a clock source and sets a
priority for the clock.
network-clock
output-source
Transmits clocking to an external timing source using a timing output
interface.