Cisco MWR 2941 - Spanning-Tree Mst Forward-Time

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
spanning-tree mst forward-time
635
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
spanning-tree mst forward-time
To set the forward-delay timer for all the instances on the router, use the spanning-tree mst forward-time
command in global configuration mode. To return to the default settings, use the no form of this
command.
spanning-tree mst forward-time seconds
no spanning-tree mst forward-time
Syntax Description
Command Default seconds is 15.
Command Modes Global configuration (config)
Command History
Examples This example shows how to set the forward-delay timer:
Router(config)# spanning-tree mst forward-time 20
Router(config)#
Related Commands
seconds Number of seconds to set the forward-delay timer for all the instances on the
Catalyst 6500 series switch; valid values are from 4 to 30 seconds.
Release Modification
12.2(14)SX Support for this command was introduced on the Supervisor Engine 720.
12.2(17d)SXB Support for this command on the Supervisor Engine 2 was extended to
Release 12.2(17d)SXB.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
15.0(1)MR This command was integrated into 15.0(1)MR.
Command Description
show spanning-tree mst Displays the information about the MST protocol.