Cisco MWR 2941 - Ptp Priority1

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
ptp priority1
349
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
ptp priority1
Sets the preference level for a clock; slave devices use the priority1 value when selecting a master clock.
The priority1 value is considered above all other clock attributes. Use the following commands to set
the ptp priority1 value.
ptp priority1 priorityvalue
no ptp priority1 priorityvalue
Syntax Description
Defaults The default value is 128.
Command Modes Interface configuration
Command History
Examples The following example shows how to enable ptp priority1 value:
Router# config t
Router# interface Vlan10
Router(config-if)# ptp priority1 128
Router(config-if)# exit
Router(config)# exit
Related Commands
priorityvalue Valid values are from 0–255. The default value is 128.
Release Modification
12.4(19)MR2 This command was introduced.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
15.0(1)MR This command was integrated into Cisco IOS Release 15.0(1)MR.
Command Description
ptp priority2 Sets the PTP priority2 value.