Cisco MWR 2941 - Clear Pw-Udp VC Counters

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
clear pw-udp vc counters
59
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
clear pw-udp vc counters
To clear counters for virtual circuits on a pseudowire connection using UDP encapsulation, use the clear
pw-udp vc counters command in user EXEC or privileged EXEC mode.
clear pw-udp vc [vcid vc-id] | [vcid vc-id-min vc-id-max] [destination ip-address | name] counters
Syntax Description
Command Modes User EXEC (>)
Privileged EXEC (#)
Command History
Usage Guidelines This command only applies to pseudowire connections using UDP encapsulation.
Examples The following example shows output from the clear pw_udp vc counters command:
Router# clear pw-udp vc destination 1.2.3.4 counters
Router#
Related Commands
vcid (Optional) Allows you to enter a specific VC ID for which counters are to be
cleared.
vc-id (Optional) The VC ID number.
vc-id-min
vc-id-max
(Optional) Range of VCs for which counters are to be cleared. The range is from 1
to 4294967295. (This argument is primarily used for legacy implementations.)
destination (Optional) Information about the VCs that have been assigned VC IDs for the
remote router you specify.
ip-address (Optional) The IP address of the remote router.
name (Optional) The name assigned to the remote router.
Release Modification
15.0(1)MR This command was introduced.
Command Description
show pw_udp vc Displays counters for virtual circuits on pseudowire connections
using UDP encapsulation.