EasyManua.ls Logo

Cisco MWR 2941 - Sabit

Cisco MWR 2941
708 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
sabit
390
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
sabit
To specify the S
an
status bit used to indicate clock quality level for the Synchronization Status Message
(SSM) in synchronous Ethernet, use the sabit command in controller configuration mode. To remove a
sabit configuration, use the no form of this command.
sabit bit-number
no sabit bit-number
Syntax Description
Command Default 4
Command Modes Controller configuration mode (config-controller)
Command History
Usage Guidelines When configuring BITS timing using an E1 connection, there are four S
a
bits within the packet that can
be used to transmit the SSM.
This command only applies to the E1 controller.
Examples The following partial configuration uses the sabit command on a BITS interface with an E1 connection
controller BITS
applique E1
framing crc4
ssm
sabit 5
Related Commands
bit-number Specifies the S
a
bit used to carry the Synchronization Status Message (SSM).
The range is from 4 to 8.
Release Modification
15.0(1)MR This command was introduced.
Command Description
ssm To enable the use of the Synchronization Status Message (SSM) on a
synchronous Ethernet connection.

Table of Contents

Related product manuals