Cisco MWR 2941 - Page 407

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
router ospf
389
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
This example shows a basic OSPF configuration using the router ospf command to configure OSPF
VRF instance processes for the VRFs first, second, and third:
Router> enable
Router# configure terminal
Router(config)# router ospf 12 vrf first
Router(config)# router ospf 13 vrf second
Router(config)# router ospf 14 vrf third
Router(config)# exit
The following example shows usage of the maximum-paths option:
Router> enable
Router# configure terminal
Router(config)# router ospf
Router(config-router)# maximum-paths?
Router(config-router)# 20
Router(config-router)# exit
Related Commands Command Description
network area Defines the interfaces on which OSPF runs and defines the area ID for those
interfaces.