Cisco MWR 2941 - Termination

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
termination
667
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
termination
Configures the DSL interface to function as central office equipment or customer premises equipment.
Use the no form of this command to remove the configuration.
termination {co | cpe}
no termination {co | cpe}
Syntax Description
Command Default The default setting is cpe.
Command Modes Controller configuration
Command History
Examples The following example shows how to use the termination command:
Router# configure terminal
Router(config)# controller shdsl2/0
Router(config-controller)# equipment-type co
Related Commands
co The WIC functions as central office equipment and can interface with
another G.SHDSL WIC configured as cpe
cpe The WIC functions as customer premises equipment and can interface with
a DSLAM or with another G.SHDSL WIC configured as co.
Release Modification
12.4(20)MR This command was integrated into Cisco IOS Release 12.4(20)MR.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
15.0(1)MR This command was integrated into Cisco IOS Release 15.0(1)MR.
Command Description
controller Configures the digital subscriber line (DSL) controller.