Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
neighbor remote-as (BGP)
257
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
neighbor remote-as (BGP)
To add an entry to the BGP or multiprotocol BGP neighbor table, use the neighbor remote-as command
in router configuration mode. To remove an entry from the table, use the no form of this command.
neighbor {ip-address | peer-group-name} remote-as autonomous-system-number [alternate-as
autonomous-system-number ...]
no neighbor {ip-address | peer-group-name} remote-as autonomous-system-number [alternate-as
autonomous-system-number ...]
Syntax Description
Command Default There are no BGP or multiprotocol BGP neighbor peers.
Command Modes Router configuration (config-router)
Command History
ip-address IP address of the neighbor.
peer-group-name Name of a BGP peer group.
autonomous-system-number Number of an autonomous system to which the neighbor belongs in
the range from 1 to 65535.
For more details about autonomous system number formats, see the
router bgp command.
When used with the alternate-as keyword, up to five autonomous
system numbers may be entered.
alternate-as (Optional) Specifies an alternate autonomous system in which a
potential dynamic neighbor can be identified.
Release Modification
10.0 This command was introduced.
11.0 The peer-group-name argument was added.
11.1(20)CC The nlri unicast, nlri multicast, and nlri unicast multicast keywords
were added.
12.0(7)T The nlri unicast, nlri multicast, and nlri unicast multicast keywords
were removed.
12.2(4)T Support for the IPv6 address family was added.
12.2(25)SG This command was integrated into Cisco IOS Release 12.2(25)SG.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
12.2(33)SRB This command was modified. The % keyword was added.
12.2(33)SXH This command was integrated into Cisco IOS Release 12.2(33)SXH. The
alternate-as keyword was added to support BGP dynamic neighbors.
12.2(33)SB This command was integrated into Cisco IOS Release 12.2(33)SB.
Cisco IOS XE Release 2.1 This command was introduced on Cisco ASR 1000 Series Routers.
To Next Page
Loading...
Need help?
General
