Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
show ethernet cfm smep
509
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
show ethernet cfm smep
To display connectivity fault management (CFM) system maintenance end point (SMEP) settings on a
device, use the show ethernet cfm smep command in privileged EXEC mode.
show ethernet cfm smep [interface gigabitethernet number]
Syntax Description
Command Modes Privileged EXEC (#)
Command History
Usage Guidelines This command allows filtering on a per-interface basis.
Alarm Indication Signal (AIS) messages are sent by default at the configured maintenance intermediate
point (MIP) level if an AIS level is not configured.
Examples The following example shows sample output from the show ethernet cfm smep command:
Router# show ethernet cfm smep
SMEP Settings:
--------------
Interface: GigabitEthernet1/1
LCK-Status: CFM Disabled
LCK Period: 60000 (ms)
Level to transmit LCK: Default
AIS-Status: CFM Disabled
AIS Period: 60000 (ms)
Level to transmit AIS: Default
Defect Condition: No Defect
interface (Optional) Displays information about an interface.
gigabitethernet (Optional) Displays information about a Gigabit Ethernet interface.
number (Optional)
• Integer from 1 to 6 that identifies a Gigabit Ethernet interface.
• Integer from 1 to 564 that identifies a port channel.
Release Modification
12.2(33)SRD This command was introduced.
15.0(1)XA This command was modified. Support for the port channel keyword was
introduced in Cisco IOS Release 15.0(1)XA.
15.0(1)MR This command was integrated into Cisco IOS Release 15.0(1)MR. This
release does not support the port channel keyword.
To Next Page
Loading...
Need help?
General
