EasyManua.ls Logo

Cisco MWR 2941 - Snmp-Server Enable Traps Ethernet Cfm Alarm

Cisco MWR 2941
708 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
snmp-server enable traps ethernet cfm alarm
615
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
snmp-server enable traps ethernet cfm alarm
To enable Ethernet Connectivity Fault Management (CFM) fault alarm traps, use the snmp-server
enable traps ethernet cfm alarm command in global configuration mode. To disable fault alarm traps,
use the no form of this command.
snmp-server enable traps ethernet cfm alarm
no snmp-server enable traps ethernet cfm alarm
Syntax Description This command has no arguments or keywords.
Command Default Traps are disabled.
Command Modes Global configuration (config)
Command History
Usage Guidelines Use this command to turn on or turn off CFM fault alarm traps.
Examples The following example shows how to enable CFM fault alarm traps:
Router#
Router(config)# snmp-server enable traps ethernet cfm alarm
Release Modification
12.2(33)SRD This command was introduced.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
15.0(1)MR This command was integrated into Cisco IOS Release 15.0(1)MR.

Table of Contents

Related product manuals