EasyManua.ls Logo

Cisco MWR 2941 - Spanning-Tree Mst

Cisco MWR 2941
708 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
spanning-tree mst
631
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
spanning-tree mst
To set the path cost and port-priority parameters for any Multiple Spanning Tree (MST) instance (including
the Common and Internal Spanning Tree [CIST] with instance ID 0), use the spanning-tree mst command
in interface configuration mode. To return to the default settings, use the no form of this command.
spanning-tree mst instance-id {{cost cost | port-priority priority} | pre-standard}
no spanning-tree mst instance-id {{cost | port-priority} | pre-standard}
Syntax Description
Command Default The defaults are as follows:
cost depends on the port speed; the faster interface speeds indicate smaller costs. MST always uses
long path costs.
priority is 128.
Command Modes Interface configuration (config-if)
Command History
Usage Guidelines Higher cost cost values indicate higher costs. When entering the cost, do not include a comma in the
entry; for example, enter 1000, not 1,000.
Higher port-priority prio values indicate smaller priorities.
Examples This example shows how to set the interface path cost:
Router(config-if)# spanning-tree mst 0 cost 17031970
Router(config-if)#
This example shows how to set the interface priority:
Router(config-if)# spanning-tree mst 0 port-priority 64
instance-id Instance ID number; valid values are from 0 to 15.
cost cost Path cost for an instance; valid values are from 1 to 200000000.
port-priority
priority
Port priority for an instance; valid values are from 0 to 240 in increments of 16.
pre-standard Configures pre-standard MST BPDU transmission on the interface.
Release Modification
12.2(14)SX Support for this command was introduced on the Supervisor Engine 720.
12.2(17d)SXB Support for this command on the Supervisor Engine 2 was extended to
Release 12.2(17d)SXB.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
15.0(1)MR This command was integrated into 15.0(1)MR.

Table of Contents

Related product manuals