Cisco MWR 2941 - Show Network-Clocks

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
show network-clocks
561
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
show network-clocks
To display information about the network clocks configured on the router, use the show network-clocks
command. The command shows the priority and state of all configured clocks and the currently selected
clock.
show network-clocks
Syntax Description This command has no arguments or keywords.
Command Modes Privileged EXEC
Command History
Examples The following example shows how to use the show network-clocks command:
Router# show network-clocks
Network Clock Configuration
Priority Source Status Type Selected
---------------------------------------------------------------
01 Packet Timing NOT OK Packet Timing N
02 E1 0/15 OK E1/T1 Y
03 BITS NOT OK BITS N
04 E1 0/14 OK E1/T1 N
---------------------------------------------------------------
Current Clock State LOCK
clock input Stratum level: 3
mode : Revertive
hold-timeout 900 sec
---------------------------------------------------------------
Release Modification
11.1 This command was introduced.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
12.2SX This command is supported in the Cisco IOS Release 12.2SX train. Support in
a specific 12.2SX release of this train depends on your feature set, platform, and
platform hardware.
12.2(33)SRD1 This command was modified to display BITS clock information for the
7600-ES+ITU-2TG and the 7600-ES+ITU-4TG.
12.4(19)MR2 This command was integrated into Cisco IOS Release 12.4(19)MR2.
12.2(33)MRA This command was enhanced to show information for REP.
15.0(1)MR This command was integrated into Cisco IOS Release 15.0(1)MR.