Cisco MWR 2941 - Ethernet Oam Remote-Failure Action

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
ethernet oam remote-failure action
160
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
ethernet oam remote-failure action
To enable Ethernet Operations, Administration, and Maintenance (OAM) remote failure actions, use the
ethernet oam remote-failure action command in interface configuration mode. To turn off remote
failure actions, use the no form of this command.
ethernet oam remote-failure {critical-event | dying-gasp | link-fault} action
{error-block-interface | error-disable-interface}
no ethernet oam remote-failure {critical-event | dying-gasp | link-fault} action
Syntax Description
Command Default Actions in response to Ethernet OAM remote failures do not occur.
Command Modes Interface configuration (config-if)
Command History
Usage Guidelines Use this command to configure an interface to take specific actions when Ethernet OAM remote-failure
events occur.
Release 12.2(33)MRA does not support sending critical-event messages but can receive all three
message types.
Examples The following example shows how to configure the action that the Ethernet 1/1 interface takes when a
critical event occurs:
Router# configure terminal
Router(config)# interface ethernet 1/1
Router(config-if)# ethernet oam remote-failure critical-event action
error-disable-interface
critical-event Specifies remote critical event failures.
dying-gasp Specifies remote dying-gasp failures.
link-fault Specifies remote link-fault failures.
error-block-interface Sets the interface to the blocking state when an error occurs.
error-disable-interface Disables the interface when an error occurs.
Release Modification
12.2(33)SRA This command was introduced.
12.2(33)SXI The error-block-interface keyword was added.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
15.0(1)MR This command was integrated into Cisco IOS Release 15.0(1)MR.