Cisco MWR 2941 - Page 561

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
show ip rtp header-compression
543
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
Connect: 16 rx slots, 16 tx slots, 0 long searches, 1 misses
99% hit ratio, five minute miss rate 0 misses/sec, 0 max.
Table 39 describes the significant fields shown in the display.
Related Commands
Table 39 show ip rtp header-compression Field Descriptions
Field Description
Interface Type and number of the interface.
Rcvd: total Number of packets received on the interface.
compressed Number of packets with compressed headers.
errors Number of errors.
dropped Number of dropped packets.
buffer copies Not applicable to the Cisco MWR 2941 router.
buffer failures Not applicable to the Cisco MWR 2941 router.
Sent: total Total number of packets sent.
compressed Number of packets sent with compressed headers.
bytes saved Total savings in bytes as a result of compression.
bytes sent Not applicable to the Cisco MWR 2941 router.
efficiency improvement factor Efficiency achieved through compression.
Connect: rx slots Total number of receive slots.
tx slots Total number of transmit slots.
long searches Not applicable to the Cisco MWR 2941 router.
misses Number of new states that were created.
hit ratio Number of times that existing states were revised.
five minute miss rate Average miss rate.
max. Maximum miss rate.
negative cache Not applicable to the Cisco MWR 2941 router.
Command Description
ip rtp
compression-connections
Specifies the total number of RTP header compression connections
that can exist on an interface.
ip rtp header-compression Enables RTP header compression.