Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
ethernet cfm mip level
132
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
In the CFM D1 implementation, you must first configure a domain using the ethernet cfm domain
command at the level you want to configure the MIP; otherwise, the ethernet cfm mip level command
is rejected. In the CFM IEEE implementation, preconfiguring a domain is not required.
You cannot configure a MIP at a level lower than the level of already configured maintenance endpoints
(MEPs) on an interface.
Configuring a MIP using this command is known as a manual MIP and has precedence over the mip
auto-create command.
Examples The following example shows how to provision a MIP at maintenance level 5 and then issue the show
ethernet cfm maintenance-points local command to display the list of configured MIPs in the device:
Router(config-if)# ethernet cfm mip level 5
Router(config-if)# Ctrl-Z
Router# show ethernet cfm maintenance-points local
Related Commands Command Description
ethernet cfm domain Defines a CFM domain.
mip auto-create Enables the automatic creation of a MIP at a maintenance
domain level.
show ethernet cfm
maintenance-points local
Displays information about maintenance points configured on
a device.
To Next Page
Loading...
