Cisco MWR 2941 - Page 208

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
ip pim
190
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
Examples The following example shows how to enable PIM-SM on tunnel interface 0 and set the address of the
RP router to 226.0.0.8:
ip pim rp-address 226.0.0.8
interface tunnel 0
ip pim sparse-mode
The following example shows how to enable PIM dense mode (PIM-DM) on Ethernet interface 1:
interface ethernet 1
ip pim dense-mode
The following example shows how to enable PIM sparse-dense mode on Ethernet interface 1:
interface ethernet 1
ip pim sparse-dense-mode
The following example shows how to register the multicast traffic for any source and any multicast
group:
interface ethernet 0
ip address 172.16.0.0 255.255.255.0
description Ethernet interface towards the PIM sparse-mode domain
ip pim sparse-dense-mode
!
interface ethernet 1
ip address 192.44.81.5 255.255.255.0
description Ethernet interface towards the PIM dens-mode region
ip pim dense-mode proxy-register list 100
!
access-list 100 permit ip any any
Related Commands Command Description
ip multicast-routing Enables IP multicast routing or multicast distributed
switching.
ip pim rp-address Configures the address of a PIM RP for a particular group.