Cisco MWR 2941 - Page 221

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
l2protocol-tunnel drop-threshold
203
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
Refer to the “Configuring IEEE 802.1Q Tunneling and Layer 2 Protocol Tunneling” chapter of the
Cisco 7600 Series Router Cisco IOS Software Configuration Guide for additional information on setting
the drop threshold value.
Examples This example shows how to set the drop threshold:
Router(config-if)# switchport
Router(config-if)# l2protocol-tunnel drop-threshold 3000
Router(config-if)#
Related Commands Command Description
l2protocol-tunnel Enables the protocol tunneling on an interface and specifies the type of
protocol to be tunneled.
l2protocol-tunnel cos Specifies a CoS value globally on all ingress Layer-2 protocol tunneling
ports.
l2protocol-tunnel
global drop-threshold
Enables rate limiting at the software level.
l2protocol-tunnel
shutdown-threshold
Specifies the maximum number of packets that can be processed for the
specified protocol on that interface in 1 second.
show
l2protocol-tunnel
Displays the protocols that are tunneled on an interface or on all interfaces.
switchport Modifies the switching characteristics of the Layer 2-switched interface.