Cisco MWR 2941 - Page 252

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
match vlan (QoS)
234
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
Note Typically, the next step would be to configure class1 in a policy map, enable a quality of service (QoS)
feature (for example, class-based weighted fair queueing [CBWFQ]) in the policy map, and attach the
policy map to an interface. To configure a policy map, use the policy-map command. To enable
CBWFQ, use the bandwidth command (or use the command for the QoS feature that you want to
enable). To attach the policy map to an interface, use the service-policy command. For more information
about classifying network traffic on the basis of a match criterion, see the “Classification” section of the
Quality of Service Solutions Configuration Guide, Cisco IOS Release 15.0S.
Related Commands Command Description
bandwidth
(policy-map class)
Specify or modifies the bandwidth allocated for a class belonging to a policy
map.
class-map Creates a class map to be used for matching packets to a specified class.
policy-map Creates or modifies a policy map that can be attached to one or more
interfaces.
service-policy Attached a policy map to an interface.