Cisco MWR 2941 - Page 288

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
network-clock output-source line
270
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
Defaults Output clocking is disabled by default.
Command Modes Configuration mode (config)
Command History
Usage Guidelines The router selects clock output interfaces based on the priority value of the clock output source.
Examples This example shows how to configure an output clock source:
Router(config)# network-clock output-source line 10 10m
Router(config)#
Related Commands
Release Modification
15.0(1)MR This command was introduced.
Command Description
network-clock
input-source
Selects an interface or external timing input as a clock source and sets a
priority for the clock.
network-clock
output-source
Transmits clocking to an external timing source using a timing output
interface.