Cisco MWR 2941 - Page 290

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
network-clock quality-level
272
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
Command History
Usage Guidelines This command only applies to synchronous Ethernet interfaces.
Examples This example shows how to configure a quality-level value:
Router(config)# network-clock quality-level rx QL-DNU controller BITS
Router(config)#
Related Commands
Release Modification
15.0(1)MR This command was introduced.
Command Description
network-clock
input-source
Selects an interface or external timing input as a clock source and sets a
priority for the clock.
network-clock source
quality-level
Specifies a quality level for a clock source.