Cisco MWR 2941 - Page 340

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
priority
322
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
Related Commands Command Description
bandwidth Specifies or modifies the bandwidth allocated for a class belonging
to a policy map.
ip rtp priority Reserves a strict priority queue for a set of RTP packet flows
belonging to a range of UDP destination ports.
ip rtp reserve Reserves a special queue for a set of RTP packet flows belonging to
a range of UDP destination ports.
max-reserved-bandwidth Changes the percent of interface bandwidth allocated for CBWFQ,
LLQ, and IP RTP Priority.
show interfaces fair-queue Displays information and statistics about WFQ for a VIP-based
interface.
show policy-map Displays the configuration of all classes for a specified service policy
map or all classes for all existing policy maps.
show policy-map interface Displays the packet statistics of all classes that are configured for all
service policies either on the specified interface or subinterface or on
a specific PVC on the interface.
show queue Displays the contents of packets inside a queue for a particular
interface or VC.