Cisco MWR 2941 - Page 355

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
ptp delay-req interval
337
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
Examples The following example shows how to configure a PTP delay-req interval:
Router# config t
Router(config)# interface vlan 10
Router(config-if)# ptp delay-req interval -4
Router(config-if)# exit
Router(config)# exit
Related Commands Command Description
ptp delay-req unicast Configures the Cisco MWR 2941 to send unicast PTP delay request
messages while in multicast mode.