Cisco MWR 2941 - Page 425

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
set cos
407
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
Note The set cos command is applied when you create a service policy in QoS policy-map configuration mode
and attach the service policy to an interface or ATM virtual circuit (VC). For information on attaching
a service policy, refer to the “Modular Quality of Service Command-Line Interface Overview” chapter
of the Cisco IOS Quality of Service Solutions Configuration Guide.
Related Commands Command Description
match cos Matches a packet on the basis of Layer 2 CoS marking.
policy-map Creates or modifies a policy map that can be attached to one or more
interfaces to specify a service policy.
service-policy Attaches a policy map to an input interface or VC, or an output interface or
VC, to be used as the service policy for that interface or VC.
set dscp Marks a packet by setting the Layer 3 DSCP value in the ToS byte.
set precedence Sets the precedence value in the packet header.
show policy-map Displays the configuration of all classes for a specified service policy map
or all classes for all existing policy maps.
show policy-map class Displays the configuration for the specified class of the specified policy
map.
show policy-map
interface
Displays the configuration of all classes configured for all service policies
on the specified interface or displays the classes for the service policy for a
specific PVC on the interface.