Cisco MWR 2941 - Page 462

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
shape (percent)
444
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
Router(config-pmap)# class-map class1
Router(config-pmap-c)# shape average percent 25 20 ms be 100 ms bc 400 ms
Router(config-pmap-c)# end
After the policy map and class maps are configured, the policy map is attached to interface as shown in
the following example.
Router> enable
Router# configure terminal
Router(config)# interface serial4/0
Router(config-if)# service-policy input policy1
Router(config-if)# end
Related Commands Command Description
bandwidth Specifies or modifies the bandwidth allocated for a class belonging to a
policy map.
class (policy-map) Specifies the name of the class whose policy you want to create or change
and the default class (commonly known as the class-default class) before
you configure its policy.
police (percent) Configures traffic policing on the basis of a percentage of bandwidth
available on an interface.
policy-map Creates or modifies a policy map that can be attached to one or more
interfaces to specify a service policy.
priority Gives priority to a class of traffic belonging to a policy map.
service-policy Attaches a policy map to an input interface or VC, or an output interface or
VC, to be used as the service policy for that interface or VC.
shape max-buffers Specifies the maximum number of buffers allowed on shaping queues.
show policy-map
interface
Displays the statistics and the configurations of the input and output
policies that are attached to an interface.