Cisco MWR 2941 - Page 641

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
spanning-tree bpdufilter
623
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
• no spanning-tree bpdufilter—Enables BPDU filtering on the interface if the interface is in
operational PortFast state and if you configure the spanning-tree portfast bpdufilter default
command.
Use the spanning-tree portfast bpdufilter default command to enable BPDU filtering on all ports that
are already configured for PortFast.
Examples This example shows how to enable BPDU filtering on this interface:
Router(config-if)# spanning-tree bpdufilter enable
Router(config-if)#
Related Commands Command Description
show spanning-tree Displays information about the spanning-tree state.
spanning-tree portfast bpdufilter
default
Enables BPDU filtering by default on all PortFast ports.