Cisco Nexus 5500 Series - Feature Http-Server

103
Cisco Nexus 5500 Series NX-OS Security Command Reference
OL-27883-02
Chapter F Commands
feature http-server
feature http-server
To enable HTTP or Hypertext Transfer Protocol Secure (HTTPS) on the switch, use the feature
http-server command. To disable the HTTP or HTTPS server, use the no form of this command.
feature http-server
no feature http-server
Syntax Description This command has no arguments or keywords.
Command Default Disabled
Command Modes Global configuration mode
Command History
Usage Guidelines In releases earlier than Cisco NX-OS Release 5.2(1)N1(1), HTTP and HTTPS are enabled on the switch
by default.
Examples This example shows how to enable the HTTP server on the switch and verify the status of the HTTP
server:
switch(config)# feature http-server
switch(config)# exit
switch# show feature
Feature Name Instance State
-------------------- -------- --------
assoc_mgr 1 enabled
cimserver 1 disabled
dhcp-snooping 1 disabled
fabric-binding 1 disabled
fc-port-security 1 disabled
fcoe 1 enabled
fcsp 1 disabled
fex 1 enabled
fport-channel-trunk 1 disabled
http-server 1 enabled
interface-vlan 1 enabled
lacp 1 enabled
ldap 1 disabled
lldp 1 enabled
niv 1 disabled
npiv 1 disabled
npv 1 disabled
otv 1 disabled
port_track 1 disabled
Release Modification
5.2(1)N1(1) This command was introduced.