Cisco Nexus 5500 Series - Show Ip Arp

280
Cisco Nexus 5500 Series NX-OS Security Command Reference
OL-27883-02
Chapter Show Commands
show ip arp
show ip arp
To display the Address Resolution Protocol (ARP) table statistics, use the show ip arp command.
show ip arp [client | [statistics | summary] [ethernet slot/[QSFP-module/]port | loopback intf-num
| mgmt mgmt-intf-num | port-channel channel-num | vlan vlan-id] [fhrp-non-active-learn]
[static] [detail] [vrf {vrf-name | all | default | management}]]
Syntax Description
Command Default None
Command Modes EXEC mode
client (Optional) Displays ARP information for ARP clients.
statistics (Optional) Display the global ARP statistics on teh switch or the ARP
statistics for interfaces.
summary (Optional) Display the ARP adjacency summary information.
ethernet
slot/[QSFP-module/]port
(Optional) Displays the ARP information for an Ethernet interface. The
slot number is from 1 to 255. The QSFP-module number is from 1 to 4. The
port number is from 1 to 128.
Note The QSFP-module number applies only to the QSFP+ Generic
Expansion Module (GEM).
loopback intf-num (Optional) Displays the ARP information for a loopback interface. The
loopback interface number is from 0 to 1023.
mgmt mgmt-intf-num (Optional) Displays the ARP information for a management interface.
The interface number is 0.
port-channel
channel-num
(Optional) Displays the ARP information for an EtherChannel interface.
The channel number range is from 1 to 4096.
vlan vlan-id (Optional) Displays the ARP information for a specified VLAN. The
range is from 1 to 4094, except for the VLANs reserved for internal use.
fhrp-non-active-learn (Optional) Displays the ARP table information learned only due to a
request for a nonactive Cisco First Hop Redundancy Protocol (FHRP)
address.
static (Optional) Displays the static ARP entries.
detail (Optional) Displays the detailed ARP information.
vrf (Optional) Specifies the virtual routing and forwarding (VRF) to use.
vrf-name VRF name. The name can be a maximum of 32 alphanumeric characters
and is case sensitive.
all Displays all VRF entries for the specified VLAN in the ARP table.
default Displays the default VRF entry for the specified VLAN.
management Displays the management VRF entry for the specified VLAN.