Cisco Nexus 5500 Series - duplex (interface)

33
Cisco Nexus 5500 Series NX-OS Security Command Reference
OL-27883-02
Chapter C Commands
cts role-based batched-programming
cts role-based batched-programming
To enable CTS batched programming, use the cts role-based batched-programming command.
cts role-based batched-programming
no cts role-based batched-programming
Syntax Description This command has no arguments or keywords.
Command Default None
Command Modes Configuration mode
Command History
Examples This example shows how to enable CTS batched programming:
switch# configure terminal
switch(config)# cts role-based batched-programming
Related Commands
Release Modification
6.0(2)N2(2) This command was introduced.
Command Description