Cisco Nexus 5500 Series - Ip Port Access-Group

130
Cisco Nexus 5500 Series NX-OS Security Command Reference
OL-27883-02
Chapter I Commands
ip port access-group
ip port access-group
To apply an IPv4 access control list (ACL) to an interface as a port ACL, use the ip port access-group
command. To remove an IPv4 ACL from an interface, use the no form of this command.
ip port access-group access-list-name in
no ip port access-group access-list-name in
Syntax Description
Command Default None
Command Modes Interface configuration mode
Virtual Ethernet interface configuration mode
Command History
Usage Guidelines By default, no IPv4 ACLs are applied to an interface.
You can use the ip port access-group command to apply an IPv4 ACL as a port ACL to the following
interface types:
• Layer 2 Ethernet interfaces
• Layer 2 EtherChannel interfaces
• Virtual Ethernet interface
You can also apply an IPv4 ACL as a VLAN ACL. For more information, see the match command.
The switch applies port ACLs to inbound traffic only. The switch checks inbound packets against the
rules in the ACL. If the first matching rule permits the packet, the switch continues to process the packet.
If the first matching rule denies the packet, the switch drops the packet and returns an ICMP
host-unreachable message.
If you delete the specified ACL from the switch without removing the ACL from an interface, the deleted
ACL does not affect traffic on the interface.
Examples This example shows how to apply an IPv4 ACL named ip-acl-01 to Ethernet interface 1/2 as a port ACL:
switch(config)# interface ethernet 1/2
switch(config-if)# ip port access-group ip-acl-01 in
This example shows how to remove an IPv4 ACL named ip-acl-01 from Ethernet interface 1/2:
access-list-name Name of the IPv4 ACL, which can be up to 64 alphanumeric, case-sensitive
characters long.
in Specifies that the ACL applies to inbound traffic.
Release Modification
5.2(1)N1(1) This command was introduced.