Cisco Nexus 5500 Series - Ip Access-Class

111
Cisco Nexus 5500 Series NX-OS Security Command Reference
OL-27883-02
Chapter I Commands
ip access-class
ip access-class
To create or configure an IPv4 access class to restrict incoming or outgoing traffic on a virtual terminal
line (VTY), use the ip access-class command. To remove the access class, use the no form of this
command.
ip access-class access-list-name {in | out}
no ip access-class access-list-name {in | out}
Syntax Description
Command Default None
Command Modes Line configuration mode
Command History
Examples This example shows how to configure an IP access class on a VTY line to restrict inbound packets:
switch# configure terminal
switch(config)# line vty
switch(config-line)# ip access-class VTY_ACCESS in
switch(config-line)#
This example shows how to remove an IP access class that restricts inbound packets:
switch(config)# line vty
switch(config-line)# no ip access-class VTY_ACCESS in
switch(config-line)#
Related Commands
access-list-name Name of the IPv4 ACL class. The name can be a maximum of 64 characters.
The name can contain characters, numbers, hyphens, and underscores. The
name cannot contain a space or quotation mark.
in Specifies that incoming connections be restricted between a particular
Cisco Nexus 5000 Series switch and the addresses in the access list.
out Specifies that outgoing connections be restricted between a particular Cisco
Nexus 5000 Series switch and the addresses in the access list.
Release Modification
5.2(1)N1(1) This command was introduced.
Command Description
access-class Configures an access class for VTY.
copy running-config
startup-config
Copies the running configuration to the startup configuration file.
show line Displays the access lists for a particular terminal line.