Cisco Nexus 5500 Series - Show Ip Dhcp Snooping

289
Cisco Nexus 5500 Series NX-OS Security Command Reference
OL-27883-02
Chapter Show Commands
show ip dhcp snooping
show ip dhcp snooping
To display general status information for Dynamic Host Configuration Protocol (DHCP) snooping, use
the show ip dhcp snooping command.
show ip dhcp snooping
Syntax Description This command has no arguments or keywords.
Command Default None
Command Modes Any command mode
Command History
Examples This example shows how to display general status information about DHCP snooping:
switch# show ip dhcp snooping
DHCP snooping service is enabled
Switch DHCP snooping is enabled
DHCP snooping is configured on the following VLANs:
1,13
DHCP snooping is operational on the following VLANs:
1
Insertion of Option 82 is disabled
Verification of MAC address is enabled
DHCP snooping trust is configured on the following interfaces:
Interface Trusted
------------ -------
Ethernet2/3 Yes
switch#
Related Commands
Release Modification
5.2(1)N2(1) This command was introduced.
Command Description
copy running-config
startup-config
Copies the running configuration to the startup configuration.
ip dhcp snooping Globally enables DHCP snooping on the device.
show ip dhcp snooping
statistics
Displays DHCP snooping statistics.
show running-config
dhcp
Displays the DHCP snooping configuration.