Cisco Nexus 5500 Series - Show Ip Dhcp Snooping Binding

290
Cisco Nexus 5500 Series NX-OS Security Command Reference
OL-27883-02
Chapter Show Commands
show ip dhcp snooping binding
show ip dhcp snooping binding
To display IP-to-MAC address bindings for all interfaces or a specific interface, use the show ip dhcp
snooping binding command.
show ip dhcp snooping binding [IP-address] [MAC-address] [interface ethernet
slot/[QSFP-module/]port] [vlan vlan-id]
show ip dhcp snooping binding [dynamic]
show ip dhcp snooping binding [static]
Syntax Description
Command Default None
Command Modes Any command mode
Command History
Usage Guidelines The binding interface includes static IP source entries. Static entries appear with the term “static” in the
Type column.
IP-address (Optional) IPv4 address that the bindings shown must include. Valid
entries are in dotted-decimal format.
MAC-address (Optional) MAC address that the bindings shown must include. Valid
entries are in dotted-hexadecimal format.
interface ethernet
slot/[QSFP-module/]port
(Optional) Specifies the Ethernet interface that the bindings shown must
be associated with. The slot number is from 1 to 255. The QSFP-module
number is from 1 to 4. The port number is from 1 to 128.
Note The QSFP-module number applies only to the QSFP+ Generic
Expansion Module (GEM).
vlan vlan-id (Optional) Specifies a VLAN ID that the bindings shown must be
associated with. Valid VLAN IDs are from 1 to 4094, except for the
VLANs reserved for internal use.
Use a hyphen (-) to separate the beginning and ending IDs of a range of
VLAN IDs; for example, 70-100.
Use a comma (,) to separate individual VLAN IDs and ranges of VLAN
IDs; for example, 20,70-100,142.
dynamic (Optional) Limits the output to all dynamic IP-MAC address bindings.
static (Optional) Limits the output to all static IP-MAC address bindings.
Release Modification
6.0(2)N1(2) Support for the QSFP+ GEM was added.
5.2(1)N1(1) This command was introduced.