Cisco Nexus 5500 Series - Show Ip Arp Inspection Vlan

287
Cisco Nexus 5500 Series NX-OS Security Command Reference
OL-27883-02
Chapter Show Commands
show ip arp inspection vlan
show ip arp inspection vlan
To display the Dynamic ARP Inspection (DAI) status for the specified list of VLANs, use the show ip
arp inspection vlan command.
show ip arp inspection vlan vlan-list
Syntax Description
Command Default None
Command Modes Any command mode
Command History
Examples This example shows how to display the DAI status for VLAN 1:
switch# show ip arp inspection vlan 1
Source Mac Validation : Enabled
Destination Mac Validation : Enabled
IP Address Validation : Enabled
Vlan : 1
-----------
Configuration : Disabled
Operation State : Inactive
switch#
Related Commands
vlan-list List of VLANs that have the DAI status. The vlan-list argument allows you to
specify a single VLAN ID, a range of VLAN IDs, or comma-separated IDs and
ranges. Valid VLAN IDs are from 1 to 4094.
Release Modification
5.0(3)N1(1) This command was introduced.
Command Description
clear ip arp inspection
statistics vlan
Clears the DAI statistics for a specified VLAN.
ip arp inspection vlan Enables DAI for a specified list of VLANs.
show ip arp inspection Displays the DAI configuration status.
show ip arp inspection
interface
Displays the trust state and the ARP packet rate for a specified interface.
show running-config
dhcp
Displays DHCP snooping configuration, including the DAI configuration.