Cisco Nexus 5500 Series - Show Ip Arp Inspection Interfaces

284
Cisco Nexus 5500 Series NX-OS Security Command Reference
OL-27883-02
Chapter Show Commands
show ip arp inspection interfaces
show ip arp inspection interfaces
To display the trust state for the specified interface, use the show ip arp inspection interfaces
command.
show ip arp inspection interfaces {ethernet slot/[QSFP-module/]port | port-channel
channel-number}
Syntax Description
Command Default None
Command Modes Any command mode
Command History
Examples This example shows how to display the trust state for a trusted interface:
switch# show ip arp inspection interfaces ethernet 2/1
Related Commands
ethernet
slot/[QSFP-module/]port
(Optional) Specifies the Ethernet interface and its slot number and port
number. The slot number is from 1 to 255. The QSFP-module number
is from 1 to 4. The port number is from 1 to 128.
Note The QSFP-module number applies only to the QSFP+
Generic Expansion Module (GEM).
port-channel channel-number (Optional) Specifies that the output is for a port-channel interface.
Valid port-channel numbers are from 1 to 4096.
Release Modification
6.0(2)N1(2) Support for the QSFP+ GEM was added.
5.2(1)N1(1) This command was introduced.
Command Description
ip arp inspection vlan Enables Dynamic ARP Inspection (DAI) for a specified list of VLANs.
show ip arp inspection Displays the DAI configuration status.
show ip arp inspection vlan Displays DAI status for a specified list of VLANs.
show running-config dhcp Displays DHCP snooping configuration, including the DAI
configuration.