Cisco Nexus 5500 Series - Page 200

186
Cisco Nexus 5500 Series NX-OS Security Command Reference
OL-27883-02
Chapter P Commands
permit icmp (IPv6)
switch(config-ipv6-acl)# permit icmp host 2001:0db8:85a3:08d3:1319:8a2e:0370:7344 any
• Any address—You can use the any keyword to specify that a source or destination is any IPv6
address. For examples of the use of the any keyword, see the examples in this section. Each example
shows how to specify a source or destination by using the any keyword.
ICMPv6 Message Types
The icmp-message argument can be the ICMPv6 message number, which is an integer from 0 to 255. It
can also be one of the following keywords:
• beyond-scope—Destination beyond scope
• destination-unreachable—Destination address is unreachable
• echo-reply—Echo reply
• echo-request—Echo request (ping)
• header—Parameter header problems
• hop-limit—Hop limit exceeded in transit
• mld-query—Multicast Listener Discovery Query
• mld-reduction—Multicast Listener Discovery Reduction
• mld-report—Multicast Listener Discovery Report
• nd-na—Neighbor discovery neighbor advertisements
• nd-ns—Neighbor discovery neighbor solicitations
• next-header—Parameter next header problems
• no-admin—Administration prohibited destination
• no-route—No route to destination
• packet-too-big—Packet too big
• parameter-option—Parameter option problems
• parameter-problem—All parameter problems
• port-unreachable—Port unreachable
• reassembly-timeout—Reassembly timeout
• redirect—Neighbor redirect
• renum-command—Router renumbering command
• renum-result—Router renumbering result
• renum-seq-number—Router renumbering sequence number reset
• router-advertisement—Neighbor discovery router advertisements
• router-renumbering—All router renumbering
• router-solicitation—Neighbor discovery router solicitations
• time-exceeded—All time exceeded messages
• unreachable—All unreachable