CHAPTER
2-1
Cisco ONS 15454 Reference Manual, R7.0.1
OL-9217-01
2
Common Control Cards
Note The terms "Unidirectional Path Switched Ring" and "UPSR" may appear in Cisco literature. These terms
do not refer to using Cisco ONS 15xxx products in a unidirectional path switched ring configuration.
Rather, these terms, as well as "Path Protected Mesh Network" and "PPMN," refer generally to Cisco's
path protection feature, which may be used in any topological network configuration. Cisco does not
recommend using its path protection feature in any particular topological network configuration.
This chapter describes Cisco ONS 15454 common control card functions. For installation and turn-up
procedures, refer to the Cisco ONS 15454 Procedure Guide.
Chapter topics include:
• 2.1 Common Control Card Overview, page 2-1
• 2.2 TCC2 Card, page 2-6
• 2.3 TCC2P Card, page 2-10
• 2.4 XCVT Card, page 2-14
• 2.5 XC10G Card, page 2-18
• 2.6 XC-VXC-10G Card, page 2-22
• 2.7 AIC-I Card, page 2-27
2.1 Common Control Card Overview
The card overview section summarizes card functions and compatibility.
Each card is marked with a symbol that corresponds to a slot (or slots) on the ONS 15454 shelf assembly.
The cards are then installed into slots displaying the same symbols. See the “1.17.1 Card Slot
Requirements” section on page 1-69 for a list of slots and symbols.
2.1.1 Cards Summary
Table 2-1 lists the common control cards for the Cisco ONS 15454 and summarizes card functions.
To Next Page
Loading...
