Cisco ONS 15454 - A.8 Storage Access Networking Card Specifications

A-49
Cisco ONS 15454 Reference Manual, R7.0.1
OL-9217-01
Appendix A Hardware Specifications
A.8 A.8 Storage Access Networking Card Specifications
A.8 Storage Access Networking Card Specifications
This section describes the FC_MR-4 (Fibre Channel) card specifications.
For compliance information, refer to the Cisco Optical Transport Products Safety and Compliance
Information document.
A.8.1 FC_MR-4 Card Specifications
The FC_MR-4 card has the following specifications:
• Fibre Channel Support: FC-0 and FC-1 layers of ANSI X3.230 FC-PH
• GBIC Line Interface
– Bit Rate: 1.0625 Gbit/s single-rate or 1.0625/2.125 dual-rate Gbit/s Fibre Channel (FC)
– Wavelength/Fiber/Reach:
850 nm, multimode fiber, 550 m (SX)
1310 nm, single-mode fiber, 10 km (LX)
1550 nm/, single-mode fiber, 80 km (ZX)
– Hot pluggable
– Auto-detection
• Transmitter
– Maximum transmitter output power: depends on GBIC type (see Table A-1)
– Minimum transmitter output power: depends on GBIC type (see Table A-1)
• Receiver
– Maximum receiver level: depends on GBIC type (see Table A-1)
– Minimum receiver level: depends on GBIC type (see Table A-1)
• Environmental
– Operating temperature
C-Temp (15454-E100T): 23 to 131 degrees Fahrenheit (–5 to +55 degrees Celsius)
– Operating humidity: 5 to 95 percent, noncondensing
– Power consumption: 60 W, 1.35 A, 221.93 BTU/hr
• Dimensions
– Height: 12.650 in. (321.3 mm)
– Width: 0.716 in. (18.2 mm)
– Depth: 9.000 in. (228.6 mm)
– Card weight: 2.59 lb (1.17 kg)