Cisco ONS 15454 - Figure 5-9 ML1000-2 Faceplate

5-24
Cisco ONS 15454 Reference Manual, R7.0.1
OL-9217-01
Chapter 5 Ethernet Cards
5.10 5.10 ML1000-2 Card
SFP modules are offered as separate orderable products for maximum customer flexibility. For details,
see the “5.13 Ethernet Card GBICs and SFPs” section on page 5-31.
Figure 5-9 shows the ML1000-2 card faceplate.
Figure 5-9 ML1000-2 Faceplate
The card features two virtual packet over SONET (POS) ports with a maximum combined bandwidth of
STS-48. The ports function in a manner similar to OC-N card ports, and each port carries an STS circuit
with a size of STS-1, STS-3c, STS-6c, STS-9c, STS-12c, or STS-24c. To configure an ML-Series card
SONET STS circuit, refer to the “Create Circuits and VT Tunnels” chapter of the Cisco ONS 15454
Procedure Guide.
The ML-Series POS ports supports VCAT of SONET circuits and a software link capacity adjustment
scheme (SW-LCAS). The ML-Series card supports a maximum of two VCAT groups with each group
corresponding to one of the POS ports. Each VCAT group must be provisioned with two circuit
members. An ML-Series card supports STS-1c-2v, STS-3c-2v and STS-12c-2v. To configure an
ML-Series card SONET VCAT circuit, refer to the “Create Circuits and VT Tunnels” chapter of the
Cisco ONS 15454 Procedure Guide.
1
2
3
4
5
6
7
8
9
10
11
ACT
FAIL
ML100T
12
0
134622
BTC192
B
a
c
k
p
l
a
n
e
BPIA
Main
Rx
BPIA
Protect
Rx
BPIA
Main
Tx
BPIA
Protect
Tx
Processor
Daughter Card
(FLASHs,
SDRAMs)
Packet
Buffer
512Kx96
Packet
Buffer
512Kx96
SSRAM
2x512Kx36
ch0-1 ch4-5
Control Mem
512Kx32
Control Mem
512Kx32
Result Mem
512Kx32
DOS
FPGA
port
2
port
3
GMII
RGGI
RGGI
RGGI
RGGI
port
A
port
B
port
3
port
2
port
0
port
1
Serdes
Serdes
SFP
GBIC
Module
SFP
GBIC
Module
MAC 1 MAC 2
port
0
port
1
GMII
Panel Port 0
Panel Port 1