15-45
Cisco ONS 15454 Reference Manual, R7.0.1
OL-9217-01
Chapter 15 Performance Monitoring
15.9 15.9 Performance Monitoring for Storage Access Networking Cards
15.9 Performance Monitoring for Storage Access Networking
Cards
The following sections define PM parameters and definitions for the SAN card, also known as the
FC_MR-4 or Fibre Channel card.
CTC provides FC_MR-4 performance information, including line-level parameters, port bandwidth
consumption, and historical statistics. The FC_MR-4 card performance information is divided into the
Statistics, Utilization, and History tabbed windows within the card view Performance tab window.
15.9.1 FC_MR-4 Statistics Window
The Statistics window lists parameters at the line level. The Statistics window provides buttons to change
the statistical values shown. The Baseline button resets the displayed statistics values to zero. The
Refresh button manually refreshes statistics. Auto-Refresh sets a time interval at which automatic
refresh occurs. The Statistics window also has a Clear button. The Clear button sets the values on the
card to zero. All counters on the card are cleared. Table 15-26 defines the FC_MR-4 card statistics
parameters.
Table 15-25 MRC Card PMs
Section (NE) Line (NE) Physical Layer (NE) STS Path (NE) Line (FE) STS Path (FE)
CV-S
ES-S
SES-S
SEF-S
CV-L
ES-L
SES-L
UAS-L
FC-L
PSC (1+1)
PSD (1+1)
LBC
OPT
OPR
CV-P
ES-P
SES-P
UAS-P
FC-P
PPJC-PDET-P
NPJC-PDET-P
PPJC-PGEN-P
NPJC-PGEN-P
PJCS-PDET-P
PJCS-PGEN-P
PJC-DIFF-P
CV-LFE
ES-LFE
SES-LFE
UAS-LFE
FC-LFE
CV-PFE
ES-PFE
SES-PFE
UAS-PFE
FC-PFE
Table 15-26 FC_MR-4 Card Statistics
Parameter Definition
Time Last Cleared Time stamp indicating the time at which the
statistics were last reset.
Link Status Indicates whether the Fibre Channel link is
receiving a valid Fibre Channel signal (carrier)
from the attached Fibre Channel device; up means
present, and down means not present.
ifInOctets Number of bytes received without error for the
Fibre Channel payload.
To Next Page
Loading...
