EasyManua.ls Logo

Cisco ONS 15454 - Ported Mode

Cisco ONS 15454
728 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3-27
Cisco ONS 15454 Reference Manual, R7.0.1
OL-9217-01
Chapter 3 Electrical Cards
3.10 3.10.2 Ported Mode
The DS3XM-12 supports three different backplane throughput configurations:
STS-48 when an XC10G or XC-VXC-10G card is used. This configuration supports the OC-48 rate
in any slot.
STS-48 for the Slots 5, 6, 12, and 13 when an XCVT card is used.
STS-12 for Slot 1 through 4, and 7 through 12 slots when an XCVT card is used. This configuration
is bandwidth-limiting in the portless mode of operation.
The backplane throughput configuration is selected in CTC card view using the Maintenance > Card tab.
3.10.2 Ported Mode
The “ported” mode supports up to 12 framed DS-3 bidirectional mapped signals to each DS3XM-12
card, where the traffic is demultiplexed and mapped into a VT1.5 payload. This payload is then mapped
and multiplexed up to a bidirectional STS-1.
3.10.3 Portless Mode
The “portless” mode allows for IXC hand off connections through a standard SONET fiber optical
interface with DS-3-mapped STS-1s as a payload. This physical connection is accomplished with any of
the OC-N cards. The system cross-connect grooms the DS-3 mapped STS1 traffic to the appropriate
DS3XM-12 card, where the traffic is demultiplexed and mapped into a VT1.5 payload. This payload is
then mapped and multiplexed up to a higher rate STS-1. See the “11.4 Portless Transmux” section on
page 11-15 for more information.
3.10.4 Shelf Configurations
The DS3XM-12 card supports the XCVT, XC10G, and XC-VXC-10G cards. The DS3XM-12 card is
supported in any of the multiservice slots (Slots 1 through 6 and 12 through 17).
The DS3XM-12 card operates at the VT1.5 level and supports a maximum of 6 or 12 ports of “portless”
(DS-3-mapped STS1s) interface, depending on the shelf configuration (see Table 3-13).
Caution Do not install low-density DS-1 cards in the same side of the shelf as DS3XM-12 cards.
Table 3-13 DS3XM-12 Shelf Configurations
Port Maximums
Slots 1 through 4, and
14 through 17
(XCVT Card)
Slots 5, 6, 12, and 13
(XCVT, XC10G, or
XC-VXC-10G Cards)
XC10G/XC-VXC-10G Shelf
(any multiservice slot)
Portless Ports 6 12 12
Ported Ports 12 12 12

Table of Contents

Other manuals for Cisco ONS 15454

Related product manuals