Cisco ONS 15454 - A.5 Electrical Card Specifications

A-15
Cisco ONS 15454 Reference Manual, R7.0.1
OL-9217-01
Appendix A Hardware Specifications
A.5 A.5 Electrical Card Specifications
– Optocoupler isolated
– Label customer provisionable
– Severity customer provisionable
– Common 32 V output for all alarm inputs
– Each input limited to 2 mA
– Termination: 50-pin AMP champ connector
• Alarm outputs
– Number of outputs: 16
– Switched by opto MOS
– Triggered by definable alarm condition
– Maximum allowed open circuit voltage: 60 VDC
– Maximum allowed closed circuit current: 100 mA
– Termination: 50-pin AMP champ connector
• Environmental
– Overvoltage protection: as in ITU-T G.703 Annex B
– Operating temperature: –40 to +65 degrees Celsius
– Operating humidity: 5 to 95 percent, noncondensing
– Power consumption: 3.00 W max., from +5 VDC from AIC-I, 10.2 BTU/hr max.
• Dimensions of AEP board
– Height: 0.79 in. (20 mm)
– Width: 13.0 in. (330 mm)
– Depth: 3.5 in. (89 mm)
– Weight: 0.4 lb (0.18 kg)
A.5 Electrical Card Specifications
This section provides specifications for the EC1-12, DS1-14, DS1N-14, DS1/E1-56, DS3/EC1-48,
DS3-12, DS3N-12, DS3i-N-12, DS3-12E, DS3N-12E, DS3XM-6, DS3XM-12, and filler cards.
For compliance information, refer to the Cisco Optical Transport Products Safety and Compliance
Information document.
A.5.1 EC1-12 Card Specifications
The EC1-12 card has the following specifications:
• Input
– Bit rate: 51.84 Mbps +/– 20 ppm
– Frame format: SONET
– Line code: B3ZS