Cisco ONS 15454 - Ds3 I-N-12 Card Performance Monitoring Parameters

15-21
Cisco ONS 15454 Reference Manual, R7.0.1
OL-9217-01
Chapter 15 Performance Monitoring
15.5 15.5.6 DS3i-N-12 Card Performance Monitoring Parameters
15.5.6 DS3i-N-12 Card Performance Monitoring Parameters
Figure 15-12 shows the signal types that support near-end and far-end PMs.
Figure 15-12 Monitored Signal Types for the DS3i-N-12 Cards
Note The XX in Figure 15-12 represents all PMs listed in Table 15-9 with the given prefix and/or suffix.
Figure 15-13 shows where overhead bytes detected on the ASICs produce PM parameters for the
DS3i-N-12 cards.
Table 15-8 DS3-12E and DS3N-12E Card PMs
Line (NE) Path (NE) STS Path (NE) Path (FE)
1
1. The C-bit PMs (PMs that contain the text “CP-P”) are applicable only if the line format is C-bit.
STS Path (FE)
CV-L
ES-L
SES-L
LOSS-L
AISS-P
CV-P
ES-P
SAS-P
2
SES-P
UAS-P
CVCP-P
ESCP-P
SASCP-P
SESCP-P
UASCP-P
2. DS3(N)-12E cards support SAS-P only on the receive (Rx) path.
CV-P
ES-P
SES-P
UAS-P
FC-P
CVCP-PFE
ESCP-PFE
SASCP-P
3
SESCP-PFE
UASCP-PFE
3. The SASCP parameter is also displayed as "undefined" for near-end parameter though it is a far-end parameter.
CV-PFE
ES-PFE
SES-PFE
UAS-PFE
FC-PFE
110718
ONS 15454
PTE
DS3i-N-12 OC-N
Fiber
DS3 Signal
DS3i Path (DS3 XX) PMs Near and Far End Supported
DS3 Signal
ONS 15454
DS3i-N-12OC-N
STS Path (STS XX-P) PMs Near and Far End Supported
PTE