Cisco ONS 15454 - G1000-4 Card

5-14
Cisco ONS 15454 Reference Manual, R7.0.1
OL-9217-01
Chapter 5 Ethernet Cards
5.6 5.6 G1000-4 Card
5.6 G1000-4 Card
The G1000-4 card requires the XC10G card. The ONS 15454 uses G1000-4 cards for Gigabit Ethernet
(1000 Mbps). The G1000-4 card provides four ports of IEEE-compliant, 1000-Mbps interfaces. Each
port supports full-duplex operation for a maximum bandwidth of OC-48 on each card.
The G1000-4 card uses GBIC modular receptacles for the optical interfaces. For details, see the
“5.13 Ethernet Card GBICs and SFPs” section on page 5-31.
Note Any new features that are available as part of this software release are not enabled for this card.
Figure 5-5 shows the card faceplate and the block diagram of the card.
Figure 5-5 G1000-4 Faceplate and Block Diagram
The G1000-4 Gigabit Ethernet card provides high-throughput, low latency transport of Ethernet
encapsulated traffic (IP and other Layer 2 or Layer 3 protocols) across a SONET network. Carrier-class
Ethernet transport is achieved by hitless (< 50 ms) performance in the event of any failures or protection
Flash DRAM CPU
67863
B
a
c
k
p
l
a
n
e
GBICs
Decode
PLD
Trans-
ceivers
Ethernet
MACs/switch
Mux/
Demux
FPGA
Inter-
face
FPGA
BTC
POS
Function
Buffer
memory
Protect/
Main
Rx/Tx
BPIAs
Power
Clock
Generation
To FPGA, BTC,
MACs
FAIL
ACT
G1000
4
RX
1
TX
RX
2
TX
RX
3
TX
RX
4
TX
ACT/LINK
ACT/LINK
ACT/LINK
ACT/LINK