Cisco ONS 15454 - DS3;EC1-48 Faceplate and Block Diagram

3-16
Cisco ONS 15454 Reference Manual, R7.0.1
OL-9217-01
Chapter 3 Electrical Cards
3.6 3.6.2 DS3/EC1-48 Faceplate and Block Diagram
Caution Do not install a DS3/EC1-48 card in Slots 1 or 2 if you have installed an MXP_2.5G_10G card in Slot 3.
Likewise, do not install a DS3/EC1-48 card in Slots 16 or 17 if you have installed an MXP_2.5G_10G
card in Slot 15. If you do, the cards will interact and cause DS-3 bit errors.
With the proper backplane EIA, the card supports BNC or SCSI (UBIC) connectors. See the
“7.2 Electrical Card Protection and the Backplane” section on page 7-5 for more information about
electrical card slot protection and restrictions.
3.6.2 DS3/EC1-48 Faceplate and Block Diagram
Figure 3-7 shows the DS3/EC1-48 faceplate and a block diagram of the card.