EasyManua.ls Logo

Cisco ONS 15454 - DS3-12 and DS3 N-12 Port-Level Indicators

Cisco ONS 15454
728 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3-15
Cisco ONS 15454 Reference Manual, R7.0.1
OL-9217-01
Chapter 3 Electrical Cards
3.6 3.5.4 DS3-12 and DS3N-12 Port-Level Indicators
3.5.4 DS3-12 and DS3N-12 Port-Level Indicators
You can find the status of the 12 DS3-12 and 12 DS3N-12 card ports by using the LCD screen on the
ONS 15454 fan-tray assembly. Use the LCD to view the status of any port or card slot; the screen
displays the number and severity of alarms for a given port or slot.
3.6 DS3/EC1-48 Card
Note For hardware specifications, see the A.5.4 DS3/EC1-48 Card Specifications” section on page A-19.
The ONS 15454 DS3/EC1-48 card provides 48 Telcordia-compliant, GR-499 DS-3 ports per card. Each
port operates at 44.736 Mbps over a single 75-ohm 728A or equivalent coaxial span. The DS3/EC1-48
card operates as a working or protect card in 1:N protection schemes, where N <= 2.
Caution When a protection switch moves traffic from the DS3/EC1-48 working/active card to the DS3/EC1-48
protect/standby card, ports on the now active/standby card cannot be taken out of service. Lost traffic
can result if you take a port out of service, even if the DS3/EC1-48 standby card no longer carries traffic.
3.6.1 DS3/EC1-48 Slots and Connectors
For SONET applications, the DS3/EC1-48 card requires an HD shelf (15454-SA-HD) and EIA (UBIC,
MiniBNC); Software Release 5.0 or greater; and XC10G or XC-VXC-10G cards.
Note The DS3/EC1-48 card supports an errorless software-initiated cross-connect card switch when used in
a shelf equipped with XC-VXC-10G and TCC2/TCC2P cards.
You can install the DS3/EC1-48 card in Slots 1 to 3 or 15 to 17 on the ONS 15454, but installing this
card in certain slots will block the use of other slots. Table 3-8 shows which slots become unusable for
other electrical cards when the DS3/EC1-48 card is installed in a particular slot.
Caution Do not install low-density DS-1 cards in the same side of the shelf as DS3/EC1-48 cards.
Table 3-8 DS3/EC1-48 Slot Restrictions
Slot Additional Unusable Slots for Electrical Cards
15 and 6
2 3 or 4 (except another DS3/EC1-48 card can be installed in Slot 3)
3—
15
16 14 and 15 (except another DS3/EC1-48 card can be installed in Slot 15)
17 12 and 13

Table of Contents

Other manuals for Cisco ONS 15454

Related product manuals