Cisco ONS 15454 - XC10 G Card; Table 2-15 XCVT Card-Level Indicators

2-18
Cisco ONS 15454 Reference Manual, R7.0.1
OL-9217-01
Chapter 2 Common Control Cards
2.5 2.5 XC10G Card
2.5 XC10G Card
Note For hardware specifications, see the “A.4.4 XC10G Card Specifications” section on page A-12.
The 10 Gigabit Cross Connect (XC10G) card establishes connections at the STS-1 and VT levels. The
XC10G provides STS-192 capacity to Slots 5, 6, 12, and 13, and STS-48 capacity to Slots 1 to 4 and 14
to 17. The XC10G allows up to four times the bandwidth of the XCVT cards. The XC10G provides a
maximum of 576 STS-1 cross-connections through 1152 STS-1 ports. Any STS-1 on any port can be
connected to any other port, meaning that the STS cross-connections are nonblocking.
Figure 2-5 shows the XC10G faceplate and block diagram.
Table 2-15 XCVT Card-Level Indicators
Card-Level Indicators Definition
Red FAIL LED Indicates that the cards processor is not ready. Replace the card if the red
FAIL LED persists.
ACT/STBY LED
Green (Active)
Amber (Standby)
Indicates whether the XCVT card is active and carrying traffic (green) or in
standby mode to the active XCVT card (amber).