Cisco PowerVu D9858 User Manual

4-48 Model D9858 Advanced Receiver Transcoder Installation and Operation Guide 4023074 Rev B
Setup Menu: Outputs
Structure
To view the Outputs menus from the Main menu, press the RIGHT arrow key once
and then the SELECT key to reach the Setup menu. Then press the RIGHT arrow
key four times and the SELECT key to view the Outputs menu.
The Outputs menu allows you to set up the rear panel control relays for alarms, the
transport stream outputs, Digital Program Mapping (DPM) and transcoding.
For instructions on how to select and store settings, see About the Front Panel,
page 4-2.
The Outputs menu has the following structure:
Cueing
Cueing Mode Trigger Polarity
Trigger High
i
s
Repeat Tone(ms) Silence(ms)
3 40 40
i
s
Seq# State Tones Mode Delay(sec)
16 Disable 999 */# 255
i
s
Relay Mode Cue Trigger Bit
Trigger 1
i
s
Main:Setup:Outputs
Cueing TS Out
i
s
MOIP1
MPEGoIP SAP SAP ID
RTP Yes Channel Name String
i
s
v46 DestAddr UDPPort SrcPort
v4 192.131.244.111 12345 12345
i
s
TS/IP Min IP/s PCR@IP Start
8 1000000 Yes
i
s
SAP MGMT Port Mode DATA Port Mode
Yes Always Output Always Output
Main:Setup:Outputs:TS Out
ASI MOIP1 DPM Transcode
SAP Multicast Address PCR Addition
192.131.244.123 Yes
Instance Name
MPEG over IP 1
i
s
ASI
Name Rate Control User Rate
ASI User 213.0
i
s
Output Mode Descramble Mode
MAP Svc Chans Only Descrambled
i
s
Name Rate Control User Rate
MOIP1 User 213.0
i
s
Output Mode Descramble Mode
MAP Svc Chans Only Descrambled
i
s
Regenerate Insert Null Packet
As Needed Yes
i
s
Regenerate Insert Null Packet
As Needed Yes
i
s
i
s
i
s
i
s

Cisco PowerVu D9858 Specifications

General

Brand	Cisco
Model	PowerVu D9858
Category	Transcoder
Language	English